About andybeller

andybeller · 12-01-2016

The Internet is full of articles advising that NetFlow v5 does not support 'ip flow egress' but I think this must be incorrect or outdated? I have configured a Cisco 7200 with only 'ip flow egress' enabled (on WAN) with NetFlow version 5 and the flow...

andybeller · 11-02-2015

Hi - I am after some information regarding max throughput using worst case senario of 64 byte packets for the the ASR series with QoS and AVC enabled. Details for the ASR1001 (2.5gbps and 5gbps) and also AR1002 would be much appreciated. Does any...

andybeller · 07-31-2012

HiAppreciate some advise on one. I have a ppp multilink with QoS applied however I do not see any matches apart from in the standard class. The router is a 10k PE router running engineering special of 12.0-30 I have tried the following with no succ...

andybeller · 05-06-2016

The BOOTREPLY from the DHCP server appears to get sent back to the interface address (where ip-helper is configured) but this is unrouteable within global table. I got this working on GNS3 by leaking the interface address into the Global table with ...

andybeller · 08-01-2012

Got to the bottom of this. The premium had been configured with 'match dscp 46' I amended to 'match ip dscp 46' and all working. Adding the 'ip' to match means it is specific to ipv4. If not used (like it was originally configured) it should match...

andybeller · 07-31-2012

Hi, thanks for responding. This is to allow us to add further serials as bandwidth upgrade at a later date with no service disruption I believe.. I will have to configure without the multilink if I am unable to get the other classes to match.

Member Since	‎09-26-2011 05:08 PM
Date Last Visited	‎04-22-2020 12:29 AM
Posts	6

User Statistics

User Activity

NetFlow v5 and 'ip flow egress'

Max QoS + AVC throughput using 64 byte packets on ASR1001 and ASR1002?

No matches on priority and enhanced classes on ppp multilink

The BOOTREPLY from the DHCP

Re: No matches on priority and enhanced classes on ppp multilink

Re: No matches on priority and enhanced classes on ppp multilink