About pavel.skovajsa

pavel.skovajsa · 06-16-2018

Hello, I started the upgrade of CSCP 3.7 -> 3.7.4 via GUI and it got stuck. So I did some research on internet, and found a way to start it manually via lcmagent-apply.tcl here: https://supportforums.cisco.com/t5/smart-net-total-care-portal-and/updat...

pavel.skovajsa · 08-31-2016

We have a fully working DMVPN phase3 where each spoke with 1 internet uplink has 4 different mGRE tunnels to 4 different Hubs (for redundancy purposes). All is working fine, all tunnels are passing traffic just fine, but for some reason always only 2...

pavel.skovajsa · 09-19-2016

For those who are interested I have worked with TAC on this, who was very helpful. It turns out the issue above is caused by us somehow ending up using same GRE tunnel keys for a pair of tunnels (Tun0+Tun1 and Tun2+Tun3) which had the same source int...

pavel.skovajsa · 09-19-2016

Thanks for the feedback. Coincidentally we were running the same release so I was worried. Turns out we have "ntp access-group peer ACL#" command, so that probably saved us. -pavel

pavel.skovajsa · 08-31-2016

Hello Ken, did you get anywhere with this one?

pavel.skovajsa · 04-17-2006

Hello,i think I read somewhere that the PIX 501 has the encyption speed of 340kb/s, so.....Also it could be a MTU and "ICMP need fragment issue". Make a sniff on the user side whether they are getting "ICMP need frament packet".Did you set up the MT...

Member Since	‎10-20-2005 12:27 AM
Date Last Visited	‎06-27-2021 12:04 PM
Posts	7
Total Helpful Votes Received	10

User Statistics

User Activity

CSCP 3.7 -> 3.7.4 upgrade loop

DMVPN Phase3 with 4 hubs - Only 2 NHS responding

For those who are interested

Thanks for the feedback.

Hello Ken,

Re: Site to Site VPN speed issues