About Nigrofasciatum

Nigrofasciatum · 04-25-2016

Hello, I'm trying to repair and optimize an old mesh network composed 1522AG and 1552E APs . APs 1552 theoretically be used with dual-band antennas (eg AIR-ANT2547V-N model) and has three connectors N, 2 Tx / Rx and Rx 1. The question is that I only ...

Nigrofasciatum · 07-03-2015

Hi, I´m trying to deploy APs 2602I in officeextend mode. According the datasheet, this AP support officeextend mode, as 1600, 3600,1700, 2700, 3700 APs series, and the OEAP600 (specially designed for this mode). The AP has the LWAPP IOS version 152-2...

Nigrofasciatum · 11-18-2013

Hello,I've been observing with multiple access points and multiple wireless clients that RSSI signal received varies even 10dBm depending on whether the device is associated with the access point or just is listening to. When is associated is the max...

Nigrofasciatum · 05-09-2012

I have a 1721 router with 3 equal routes to 0.0.0.0, using CEF for load balancing with universal load balancing algorithm. It doesn`t NAT, just routing. I wonder which is the maximum capacity of the router, since it should support up to 40000 connect...

Nigrofasciatum · 05-19-2011

What is the regulatory domain in mexico? I have reviewed the information from Cisco, and I see conflicting information, because in some places is domain-A and other is-N domain. Can I operate on 1-11 indoor channels or only from 2450 to 2483 MhZ?Has ...

Nigrofasciatum · 04-20-2015

Yes, you should use the option 802.11b/g. You continue seeing the radios 5ghz on, because you are not disabling radios, you only are not broadcasting your ssid on the 5 ghz radios. 5ghz are useful in high density or interferents enviroments.

Nigrofasciatum · 04-20-2015

You can try to introduce a power injector between the switch and the AP, at less than 100 meters from the A . You´ll guarantee the AP receives PoE correctly. However , the cable distance facing the 802.3 Ethernet protocol remains of 200 meters , and ...

Nigrofasciatum · 04-20-2015

You can apply radio policies on SSID basis. If there is a unique SSID in the hotel, you can configure the SSID only at 2.4GHz.Otherwise, it makes sense to create a RF profile with radio policies to apply (you can disable all 5GHz data rates). Then, c...

Nigrofasciatum · 04-20-2015

The important thing is not "see " but " hear". There may be two APs with no line of sight , but still they are mutually listening to their broadcasts. This situation must be avoided .In order to avoid co-channel interference, an AP can not "hear" oth...

Nigrofasciatum · 04-20-2015

There is a problem in the CDP negotiation between the AP and switch. The AP 1702 (standalone) demand to 16.8 watts ( most of 15.4W that supports PoE ) , which causes the port off and on again to restart the negotiation CDP . Now when you connect the ...

Member Since	‎02-14-2007 12:26 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	32
Total Helpful Votes Received	5

User Statistics

User Activity

Single band antenna workaround

AP 2602I OfficeExtend mode

Interpretation RSSI measurements

Maximum router CEF capacity

Mexico regulatory domain

Yes, you should use the

You can try to introduce a

You can apply radio policies

The important thing is not

There is a problem in the CDP