About Clay Plaga

Clay Plaga · 03-04-2024

I am taking a new job that requires me to troubleshoot client login and connection to Cisco AnyConnect VPN. I do not have much experience with this task. I have two questions:1. Does Cisco Any connect have a admin center for configuring the applicati...

Clay Plaga · 09-30-2023

I have a Cisco 2504 WLC and 3 Cisco 1142n access points on my test network. The 2504 WLC and AP's have been off for a few months and I 'm trying to put the wi-fi back online. I am just learning how to configure this system. The 2504 WLC boots up oka...

Clay Plaga · 10-07-2022

I have a Cisco 2911 router with VOIP bundle installed. If I reset the router to factory default, will the flash be affected?Thank you.

Clay Plaga · 10-01-2022

I have a test network setup in my house. I have 2 Cisco 2911 routers with a switch module installed. One of the 2911 routers is my main switch\router. I have a switch module installed on this router. I am using both slots on this router, one slot has...

Clay Plaga · 09-29-2022

I have an SM-SRE-700 voice module. Can I install this module in a Cisco 2911 router? The SM-SRE-700 voice module was pulled from a Cisco 2911 at my job that was not being used. I have a test network with working Cisco phones running on the 2911. I wa...

Clay Plaga · 10-02-2023

Thank you for your help. Yes, my DNS entry for the WLC is correct. The new DNS entry is:Cisco-Capwap-Controller.photonicss.com 192.168.5.4(the IP address of the 2504 WLC)And the IP address is correct. The IP address is the same. 192.168.5.7(the domai...

Clay Plaga · 10-02-2023

Thanks again for all your help. I think I may have found the problem. I took a good look at the AP log output, and I see the WLC is looking for:photonics.orgThis WLC was connected to another domain called photonics.org. The new domain is:photonicss.c...

Clay Plaga · 10-01-2023

Yes, I can post the boot logs from the AP. I just found the steps to configure & view the WLC logs. I will post the logs tomorrow afternoon when I'm in front of the gear.Another question. If I was trying to teach myself up do date Cisco wi-fi adminis...

Clay Plaga · 10-01-2023

Are you saying that it is not possible to connect the 1142n to the 2504 WLC? The AP was connecting to the WLC about 6 months ago. I've had it turned off until now. Is there anyway I can get it to work?Thank you for your help.

Clay Plaga · 10-01-2023

Sorry for the delay. Thank you for your assistance, I really appreciate it. This is a test network I am using. I am using a 2504 WLC. The version software is 8.3.143.0. I am using NTP from my domain controller, and the time is correct. Also I have t...

Member Since	‎02-28-2013 03:43 PM
Date Last Visited	‎03-06-2024 12:10 AM
Posts	189
Total Helpful Votes Received	30

User Statistics

User Activity

Basic troubleshooting steps for Cisco AnyConnect VPN client

Assistance joining cisco 1142n to Cisco 2504 WLC

Reset Cisco 2911 to factory default

Help configuring SM-SMR-700-KB voice module on seperate 2911 router

Voice module for Cisco 2911 router

Re: Assistance joining cisco 1142n to Cisco 2504 WLC

Re: Assistance joining cisco 1142n to Cisco 2504 WLC

Re: Assistance joining cisco 1142n to Cisco 2504 WLC

Re: Assistance joining cisco 1142n to Cisco 2504 WLC

Re: Assistance joining cisco 1142n to Cisco 2504 WLC