Hello All,
We wish to allow some of our extensions to dial only a list of external numbers (the list has nearly 30 numbers in it), Is there a way on call manager to achieve this, apart from creating a route pattern for each number?
Dear All, I am in an urgent need to solve this error. I have cucm 10 at a client site but the trial licence is expiring soon so I wanted to install a new cucm 10 from PCD so that i get a few days trial in the mean while the client will purchase ...
Hi,Dear All, I have 2 cisco 9971 ip phone and Call manager 8.5 , Whenever I try to make any calls from that phone , there is a persisting noice in the back, Both the phones have the same problem, All though all other model phones seems to be wor...
Dear All, I have a cisco DMM 5.1 with some players installed on it, I can login to the dmm 5.1 via web browser but I cannot login the hardware directly through the console, I dont have the password for the console access, Could any one plea...
Hi Jaime,
Thank you for the reply, i was thinking there might be something like translation pattern, so that i can point the cucm to check if the pattern is present in the translation pattern and then route the call (like we do for call blocking ...
I was facing the above problem because of my source CUCM server not being licensed. I guess we need the source CUCM licensed in order to migrate it to other server.
I was facing the above problem because of my source CUCM server not being licensed. I guess we need the source CUCM licensed in order to migrate it to other server.
Hi Anas,I tried that already, Sorry i dint told you that, When i connect directly to the switch the noise reduces to some extent you could say, the noise is minimal (but not gone) when I connect directly to the switch.
yes , I hear the same noise on the speaker as well, Its a very small setup with 2 cisco 9971 and 4 or 5 cisco 7940 phones, and they are all in the local network, Do you think QOS is required for this? as the problem persist only with these two phones...