About microfeel

microfeel · 04-14-2013

For example I have a border router with two ports, first port is wan port and another port is lan port. How many VLANs possible to assign to a router port?

microfeel · 05-07-2012

Today on a site I have found the opinion:"Loopback interfaces are logical and maintained within software and *NEVER* go down as long as the router is turned on and operating (unless you "no" them). Anyone who uses a subinterface as a loopback inte...

microfeel · 04-13-2012

I want to connect my clients from the Windows WS to a VPN Tunnel using 3925 router w/o Cisco VPN client. Is there the way to use native IPSec client on Windows XP or Windows 7?

microfeel · 04-11-2012

Hi, All!While booting Cisco I see three warning messages.What have to do to resole it?=~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2012.04.11 20:38:38 =~=~=~=~=~=~=~=~=~=~=~=c3925#reloadProceed with reload? [confirm]Apr 11 14:42:46: %SYS-5-RELOAD: Reload reques...

microfeel · 03-11-2012

I have config like that, for Cisco router:interface GigabiteEthernet0/0.2 encapsulation dot1Q 2 ip address 192.168.2.2 255.255.255.0interface GigabiteEthernet0/1.2 encapsulation dot1Q 2 native ip address 192.168.1.1 255.255.255.0ip 0.0.0.0 0.0.0.0 19...

microfeel · 04-14-2013

Hi Inayath,I saw a design of network like belowISP <--> [fastethernet0/1]SWITCH1[fastethernet0/2]<--> ROUTER<--> SWITCH2When I asked about the SWITCH1 purpose on the scheme I was told the purpose of the SWITCH1 to terminate VLANs.So why I asked that...

microfeel · 04-14-2013

Hi Inayath,I understud from your words there is hardware restriction.Is there another restriction for VLAN assignments to a router ports?

microfeel · 03-21-2012

The subject is closed. Everybody thank!

microfeel · 03-15-2012

1. add vlan, for example with id 2.2. add ip address in vlan 2.3. port which connected to your computer must be vlan 2 native mode acces, all trafic trought out from this port will untaged.use command switchport mode accessorencapsulation dot1q 2 nat...

microfeel · 03-15-2012

1. Find out port com number in device meneger. There must'n be conflicting devices by IRQ. Use some port in putty.2. Hit enter key twice. You will see promt.3. Check your config. This port don't have to be disable. Enable by default.

Member Since	‎09-18-2011 06:36 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	17
Total Helpful Votes Received	15

User Statistics

User Activity

How many VLAN possible to assign to a router port

Looking for the truth about the loopback interface

Acces to LAN through Internet w/o Cisco VPN client

Warning messages while booting

How to assign VLANs?

Re: How many VLAN possible to assign to a router port

How many VLAN possible to assign to a router port

How to assign VLANs?

No web access since using VLAN (SGE2000)

Unable to connect from Putty to Cisco Switch