About adam dirkmaat

adam dirkmaat · 04-22-2014

I've just constructed a remote DMVPN spoke that has a 300Mbps private point to point circuit back to the data center. My manager promised an SLA of < 20ms at 50% bandwidth utilization (I think he made that up?!). I'm trying to sort out the best way...

adam dirkmaat · 08-17-2012

I'm re-designing a couple of wan sites. I'm using EIGRP over both some leased dark fiber and p2p provider connections. The attached (pdf) physical topology says it all, I'm thinking of using ip sla to track and inject routes over prefered connectio...

adam dirkmaat · 05-23-2014

Yes, I realized using udp you can specify bandwidth and then validated my results using netflow/solarwinds. I then initiated a ping over the link and documented the RTT. I also learned in this processes, that RTT delay isn't really introduced until...

adam dirkmaat · 04-23-2014

Let me add something to this discussion... how can you simulate 50% load on a circuit to then test/document latency at 50% bandwidth utilization? This is for capacity planning purposes.

adam dirkmaat · 04-23-2014

Thanks for the response. I'm familiar with iperf, the challenge is how to simulate 50% bandwidth load (150Mbps) over the available 300Mbps link. If I push a large file, all available bandwidth is used.Additionally, this is sort of a capacity planni...

Member Since	‎04-02-2012 06:18 PM
Date Last Visited	‎10-25-2017 01:43 PM
Posts	5

User Statistics

User Activity

How can i simulate 50% load on a point to point WAN circuit in order to measure latency for a predetermined SLA?

multiple WAN site redundancy design review (dark fiber, p2p, DMVPN)

Yes, I realized using udp you

Let me add something to this

Thanks for the response. I'm