Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About Kyle Albasha
Stats
Member since
08-08-2012
32
Posts
0
Helpful
0
Solutions
03-11-2015
02:06 PM
I restart host machine pub first and then sub tfpt server sec still getting same resuult tftp timeout no trusted list install
... View more
03-11-2015
10:32 AM
Optin 150 is correct cauz i see the correct TFTP server ip address on Alternat TFTP server however i didn't install Device pack on all servers only on the pub and only restart TFTP services to confirm we need to install device pack on server and restart the cluster ?
... View more
03-11-2015
10:06 AM
I'm running Cisco CallManager System version: 8.6.2.25900-8 on our envirment and we are in the process of deplying a Cisco 8811 phone. Step i took Install Device Pack Reset TFTP services configure the cisco 8811 ph however getting error message Telephone service is unavaliable TFTP timeout No trust list installed
... View more
Labels:
Created by
Kyle Albasha
in IP Telephony and Phones
in IP Telephony and Phones
09-10-2014
02:56 PM
09-10-2014
02:56 PM
Notice Default Router 1,2,3,4,5 are blank
... View more
09-10-2014
02:55 PM
these are a new 7962 phone that we are peploying remote. the phones are getting correct IP address address from DHCP correct TFTP address however we are getting tftp timeout error If I go into the options menu and view IPv4 Configuration, it says: DCHP - Enabled IP Address - 10.68.44.11 Subnet Mask - 255.255.255.0 Default Router 1,2,3,4,5 are blank DNS Server 1 - 10.232.0.15 DNS Server 2 - 10.232.0.14 DNS Server 3 - 10.224.95.15 DNS Server 4 - 10.224.96.14 DNS Server 5 - 10.216.0.15 DHCP Server - 10.232.0.46 DHCP Address Released - No Alternate TFTP - No TFTP Server - 10.138.244.21 TFTP Server 2 - BOOTP Server - No MAC address - 3COE236D5FF3 Host Name - SEP3C0E236D5FF3 Domain Name - Infosolco.net Operational VLAN ID - 20 Admin. VLAN Id - SW Port Configuration - Auto Negotiate PC Port Configuration - Auto Negotiate PC VLAN - VPN - Not Connected
... View more
09-10-2014
01:54 PM
Running callmanager 8.6.2 and have cisco 7962 and 7961 deploy in one of our site utilizing SCCP however the ssue: currently I'm unable to get my 7962 or 7961 phone to register with cucm. Error message on 7962 phone "TFTP Timeout" any idea
... View more
Labels:
08-21-2014
09:10 AM
Hello I'm running callmanager v 8.6.2 with a hunt pilot configuration utilizing and h list and line group my q how do i configure my pilot number to Forward Hunt No Answer & Forward Hunt Busy to internal number .? tried to set the number directly into section Hunt Forward Settings with Calling Search Space internal and didn't work what is the correct way?
... View more
Labels:
07-15-2014
09:30 AM
how could i do that? . my current config is as follow system call handlers for main menu with time of day schedule set greeting standard with options 1,2,3 ,4 cloes greeting with option 1 only how do i send the call during close hour to different ch
... View more
07-15-2014
08:54 AM
how do you setup a different caller input for business hours vs closed on a system call handlers ? Unnity connection 8X
... View more
Labels:
Created by
Kyle Albasha
in IP Telephony and Phones
in IP Telephony and Phones
07-14-2014
09:35 AM
07-14-2014
09:35 AM
Based on our sites DID ranges we currently don't have an overlap extension . is it possible to set a location code perhaps + 4 digits dilaing ? if so
... View more
Created by
Kyle Albasha
in IP Telephony and Phones
in IP Telephony and Phones
07-14-2014
09:29 AM
07-14-2014
09:29 AM
thx David however currently we don't use a 9 or a 1 to make a call , also we use Intra-site, on-net abbreviated dialing within the sames site. all of our endpoint is configure as a 10 digits numbers
... View more
07-14-2014
09:06 AM
hello we are running one cluster callmanager ver 8.65 among ver sites utilizing a ten digites dialing configuration on the IP phones. however the q how do you setup a 4 digites dilaing among all site within the same cluster? utilizing a SIP configuration
... View more
Labels:
10-31-2013
08:36 PM
running a unity connection ver 8.62 for all my sites , however i had an issue with one of my site today when a user attempte to hit the message button off his cisco 7962 phone he is not connecting to to the voice mail . we get nothing however when i dial the ex # internaly i retreive the default cisco message greeting . this is an issue with this site only hermosillo & everyone else can connect to the voice mail without any issue any idea call manager ver is 8.62 as well
... View more
Labels:
04-16-2013
12:36 PM
I'm running Cisco UCS call manager ver 9.1 with Cisco 8961 Phones . some of the phones received a reboot for a few second and came back up . i have checked call manager trace log and there is no downtime releate issue i have looked at the sw and everythings looks good . the sw log didnot indecate downtime any suggestion what look for?
... View more
Labels:
Created by
Kyle Albasha
in Switching
in Switching
03-19-2013
02:44 PM
03-19-2013
02:44 PM
How do setup win xp to regenoize serial connection com port ? all i see is com 1 and 2 however my console cable on Com3
... View more
03-11-2015
I restart host machine pub first and then sub tfpt server secstill
getting same resuulttftp timeoutn...
03-11-2015
Optin 150 is correct cauz i see the correct TFTP server ip address on
Alternat TFTP serverhowever i ...
03-11-2015
I'm running Cisco CallManager System version: 8.6.2.25900-8 on our
envirment and we are in the proce...
09-10-2014
these are a new 7962 phone that we are peploying remote. the phones are
gettingcorrect IP address ad...
09-10-2014
Running callmanager 8.6.2 and have cisco 7962 and 7961 deploy in one of
our site utilizing SCCP howe...
08-21-2014
HelloI'm running callmanager v 8.6.2 with a hunt pilot configuration
utilizing and h list and line g...
07-15-2014
how could i do that? . my current config is as followsystem call
handlers for main menu with time of...
07-15-2014
how do you setup a different caller input for business hours vs closed
on a system call handlers? Un...
07-14-2014
Based on our sites DID ranges we currently don't have an overlap
extension . is it possible to set a...
07-14-2014
thx Davidhowever currently we don't use a 9 or a 1 to make a call , also
we use Intra-site, on-net a...
07-14-2014
hellowe are running one cluster callmanager ver 8.65 among ver sites
utilizing a ten digites dialing...
10-31-2013
running a unity connection ver 8.62 for all my sites , however i had an
issue with one of my site to...
04-16-2013
I'm running Cisco UCS call manager ver 9.1 with Cisco 8961 Phones . some
of the phones received a re...
Public Statistics
| Date Registered | 08-08-2012 02:57 PM |
| Date Last Visited | 12-07-2018 09:35 AM |
| Total Messages Posted | 32 |
