Background:ASR1002 with ASR1002-SIP10 - started receiving PLIM status messages%CMCC-3-PLIM_STATUS: SIP0: cmcc:  A PLIM driver informational error SPA1 L2 protocol field offset past packet EOP, block 1b count cAny insight would be helpful, these error...

Can anyone point me to a FWSM doc detailing IPV6 support? I know that V6 is only supportedin routed mode and there is no failover. Is there a roadmap or is the module being phased out?mike

I am trying to configure MP-BGP to advertise V6 prefixes via a V4 peering session. I was able to make this workutilizing a non VRF configuration and address families. The solution requires dual stack configuration on the peering interface for V6prefi...

Is nbar supported with ipv6 capable IOS? Is there information on itsIOS introduction? I assume that the applications/traffic recognized is a subsetof the v4 traffic recognized? Any help in this area to verify that IPV6 and NBARare comapatible would b...