About AndrewISPNET

AndrewISPNET · 04-10-2013

Hi All,I am replacing a 7204 router with a 4948 and am having trouble trying to replicate the config for the qnq Layer3 interface.A bit of background - I am a service provider where I have an interconnect with the carrier, who pass off WAN links to ...

AndrewISPNET · 04-17-2013

Thanks for your help - next question - Is there a way I can simulate this in dev before I put it into Production?I have 2 x 3550 Switches, and the 4948Have configured as follows - but am getting Encapsulation errors.Physically:Port 1 on each switch a...

AndrewISPNET · 04-11-2013

Thanks Guys,So to Confirm, doing it this way just means I have to have unique Internal VLANs per customer? Then I can just put the VLAN interface in the customer VRF and all should work OK?interface GigabitEthernet0/14description ISP Interconnectswi...

AndrewISPNET · 04-11-2013

So is there no way to have the Layer 3 Subinterfaces on the switch rather than the router? I am trying to remove the 7200 from the network.Or do I still need a router to create the subinterfaces on the 7200?Also - with the loop is that a physical loo...

AndrewISPNET · 04-10-2013

It is handed to us as Layer 2 only.So I am connected to 7 carriers, and have assigned a block of VLAN IDs to each carrier, so there is no overlap.Trunk to the carrier with seperate VLAN ID for each site.On the physical port (Switchport) i would have...

Member Since	‎04-10-2013 03:50 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	5

User Statistics

User Activity

Help with second-dot1q interface on 4948

Help with second-dot1q interface on 4948

Help with second-dot1q interface on 4948

Help with second-dot1q interface on 4948

Help with second-dot1q interface on 4948