Level 1
Level 1
Member since ‎08-10-2010

User Statistics

  • 16 Posts
  • 0 Solutions
  • 4 Helpful votes Given
  • 0 Helpful votes Received
Recent Badges
5 Replies

User Activity

Hello there,In the past i wroked with VWIC1 or 2, and i had the habit to uses RJ48 pinout only to bind telco access point to the Cisco's voice card (as wrote down here).Today, i had to play with a VWIC3, and my fellows told me that i don't have to us...
Hi dear community,For a quite old ToIP installation, i'm facing many issues, and requiring your skills.The architecure is quite basic, two sites with tow CCME 4.0 with a sip trunk between them.[IPPhones Site A]-----sccp----[CCME of site A]-----WAN (s...
Hello,I Have an IPPHone A with DN configured in single line.IPPHone A is in conversation, if another IPPHone (B) calling A, then B gets the busy tone. But if an incoming external (from pstn) tried to reach A (which is already in a call), the pstn inc...
Hi dear community,One of my client wants to configure VG200 (224) series in CUCM (8.6) via Kurmi.He asked me how was calculated the address mac ports of the VG. After send him the official answer of Cisco (that is on the online help of the cucm), I f...
Hello dear community,I never configured ATM or DSL interface, but i need to know hat the configured rate line interface stand for?Because, even on a 2 or 4 -Wire configuration, sometimes the addition of the line-0 rate and line-1 rate is less or supe...
Community Statistics
Member Since ‎08-10-2010 07:11 AM
Date Last Visited ‎08-18-2017 03:56 AM
Posts 16
Helpful Votes Given To