Hi, we are trying to get the following scenario to work. - ASA5506 in transparent mode (L2 filtering)- on the inside zone we have a switch with several hosts connected to that switch- the hosts get an IP address from a DHCP server which is not under ...
Hi,
I am looking for design solutions for the following problem.
Context:
We have a “system” that we provide to our customers. Each system comprises several PCs connected to a network switch (the switch is internal to the system). The system can be...
LS,
my goal is to setup an ASA5506 (without Firepower, etc) to a predefined configuration.
For this I use a configuration file which should replace the startup-config.
To put the file on the system (including the firmware version 9.8.2) I use the...
Hi Guys, I need to configure a bunch of ASA5506 devices. One way of doing so is to "copy and paste" the new configuration via the terminal emulation software.However I do not like this approach so I tried the following:- Created a file containing th...
Hi,I am experimenting with a Cisco 871 router. The router has 4 LAN ports and 1WAN port.What are the limitations wrt to the LAN ports when it comes to routing. Is the WAN port the only port that supports routing?Regards,Tom
Some additional information:- the mobile device (in fact it is a kind of PC with one NIC) connects via a wired connection to the "internal" network switch but is moved between systems.- The mobile device is in the same VLAN as all o...
Hi, I invested some more on the problem and this is what I found.
If one makes a copy of the startup-config then the system puts it some annotations in the file (see below).
It turns out that these are essential to get the exact same configuration....
Thanks for the feedback. I need to automate the configuration of the ASA device as we deliver it as part of our product (so lots of devices to configure).I don’t want to do the manual change afterwards to error prone.I had hoped that somebody has see...
Thanks for the quick reply, your proposed solution works (and thanks for pointing out that the post is in the wrong location, sorry for that).I initially decided to copy to the startup-config because I did not want the configuration from the file bei...
Thanks for the help.I managed to get the setup working.Besides the VLAN / SVI setup I found two additional problems.I forgot to setup the ports that connect the two routers as "trunk" ports (switchport mode trunk , switchport trunk encapsulation dot1...