Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Team,We have got CUCM 7.1.3.32900-4 at one of our sites. We have been reported that Conference calls are not working since morning. I have verified the Media Resource Group and found all the resources were selected (Software CFB & Hardware CFB). Then...
Hi Team,
We have got an issue at our new 10.5.1 cluster. We have SIP Trunks provided by Verizon at Leeds UK. We have enabled the Enterprise Mobility (Single Number Reach) for our executives. But Mobility feature is working fine for internal calls but...
Hello Team, We are migrating our Physical cluster (Pub & Sub) 8.5.1 SU2 to UCS 10.5.1 using Cisco PCD. We have installed PCD and discovered existing cluster to it. While performing migration task, can we proceed with Pub & Sub at same time or you wan...
Hi Team,We have a 8.5.1 Su2 cluster in EMEA. As we are shifting Voice devices CUCM Pub & UCCX Pub) from Leeds to Amsterdam, I have changed the IP Address of our CUCM Pub, so that it will go and sit in Amsterdam LAN. My question over here is, when I b...
Hi Team,We have CUCM 8.5.1 SU2 cluster in EMEA, Publisher in Leeds & Subscriber in Hammer smith. We have these software's loaded in MCS 7825I5 boxes. Now we are planning to move these servers from these locations to Amsterdam Data Center. We are als...
Hello Bj,
I have installed couple BE6KS, it is pretty smooth and straight forward. As mentioned in earlier posts, BE6KS will come with pre configuration. You can ignore all of these configurations and reconfigure with your site specific configurati...
Hello Shiva, Have you Installed BE6K S at your site. If yes can you please get me the steps around it, apart from Quick Start Guide. I have one Implementation scheduled next month. ANy Help much Appreciated.Regards,Solomon
Finally Conference Call worked, after I remove Software Conference Bridge from MRG. Currently only Hardware CFB has been included. I will let this setup remain for the next couple of days. But problem over with this is, I have configured only two ses...
10.204.14.11 is CUCM IP and 10.204.14.5 is MGCP Gateway.Currently in the selected MRG, I have included both Software and Hardware Conference Bridges.Basically CUCM has been deployed in Australia. 30 odd Cisco 6921 IP Phones registered to CUCM in AU ...
Hi Mohammed, Please find the output. My Question over here is, even internal calls fail as soon as I initiate Conference, which makes me annoy. AU-Sydney-VGW01#sh sccpSCCP Admin State: UPGateway Local Interface: GigabitEthernet0/0 IPv4 Address...
