About Andrew Schulz

Andrew Schulz · 11-12-2015

I'm running a Cisco 1941 and need to set a vpn-session-timeout for just the WebVPN users. I've attempted using the following command hostname(config)# group-policy FirstGroup attributes hostname(config-group-policy)# vpn-session-timeout {minutes | n...

Andrew Schulz · 10-08-2014

Hi,I'm working on segmenting my network for users that are members of Finance. These users are distributed among several locations, each site is connected over MPLS Layer 2 network. At Site A I have a VLAN 10 setup with the Finance users at that loca...

Andrew Schulz · 01-06-2014

Hi all,I am trying to figure out how to FTP to my Prime installation to export reports to SQL Reporting services. I first attempted to change the location under Administration > System Settings > Report but see that it must be local. Now what I think...

Andrew Schulz · 02-11-2013

Hi, I want to setup a webpage for my guest network (no authentication) users. When the client connects to the open guest network and upon opening a browser they would be directed to a survey that I would like them to take, if they don't want to take ...

ISE - Authorization Profile issue · 08-16-2012

I'm running a trial of ISE and I'm attempting to create the authorization profile with the following settings:Name: Posture_RemediationAccess Type: Access_AcceptCommon Tools: Posture Discovery, EnabledPosture Discovery, ACL ACL-POSTURE-REDIRECTThe do...

Andrew Schulz · 11-13-2015

That would explain it. Thank you Dinesh.

Andrew Schulz · 10-09-2014

Thank you for your help on this. I think I knew this in theory and just needed someone to walk through it with me. I now have an ACL on the VLAN 10 interface at Site B that permits 172.16.100.0 0.0.0.255. Implicit deny on everything else. Works.

Andrew Schulz · 10-09-2014

Since I'm controlling access at Site A via a Firewall, I think what I need is to control access to VLAN 10 at Site B. What I want ultimately is to deny all subnets with the exception of 172.16.1xx.0 at all sites. This is my first site that I am sett...

Andrew Schulz · 10-09-2014

Ok, so the routing works as I described above. One interesting note is that the loop occurs if no device is attached. Once I connected a laptop to that subnet the loop did not occur. Learn something new every day. At this point my routing is good. No...

Andrew Schulz · 10-09-2014

Thank you for talking through this. So, I setup the following and when I trace route it loops at the remote site.Site AVLAN 10 - 172.16.100.0/24Firewall (Gateway) - 172.16.100.1Client 1 - 172.16.100.2Site BVLAN 10 - 172.16.121.0/24Router VLAN 10 IP -...

Member Since	‎08-26-2010 09:29 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	105

User Statistics

User Activity

Cisco ISR 1941 WebVPN vpn-session-timeout

Route VLAN across WAN (MPLS)

Prime 1.3 and FTP to Reports

Guest WLAN Spalsh page to external URL

ISE - Authorization Profile issue

That would explain it. Thank

Thank you for your help on

Since I'm controlling access

Ok, so the routing works as I

Thank you for talking through