I'm currently developing a script for automating the process of bringing up a new location i DNA-C. The following steps are completed:Discover device(s) on the locationCreate site hierarchyAssign device(s) to the created siteSoftware image distributi...
We have been using VPLS on Cat6880 as shown below in PE1 and PE2. PE1 is routing traffic destined out of the VLAN.After replacing Cat6880 with Cat9500 (16.12.01c) we are no longer able to configure an IP address on the SVI. When trying, the following...
In earlier versions of LMS it was possible to choose i.e. the Routers category (top level) and enter a series of commands to be excluded from the comparison. In LMS 4.0.1 I experience, in several different installations, that this is not possible. It...
Right-clicking on a device in the Topology Map gives you the opportunity to SSH to the device. Have used various solutions to make this work over the last few years, but I'm not able to figure out a solution when the client is running Windows 7. Anyo...
In the network of my latest LMS 3.2 installation a lot of the devices is presenting a telnet prompt with a lowercase "u" in username. This seems to cause the RME to not be able to login to the devices. I remember from earlier that it was possible to...
Thank you! Looking forward to testing your solution. I have been in contact with TAC, and they told me there is currently no plans for implementing these APIs. I am also running a case with Cisco here in Norway.
Many thanks for your reply, Joseph.The 7Ks are running 5.2(1) for the time beeing, but the customer is planning an upgrade to 5.2(4) i June. I will have a check on the NTP sync after this.
BumpI'm experiencing the same behaviour using a VSS as NTP server and N7K as client. The N7K has no problem getting its NTP from external NTP servers, but when pointing it to the VSS, it never gets synced. Obviously routing issues, acls and so on is ...
