Just have great fun on a layer2 3560 thanks to Cisco and Stardust!So I just received a 3560 from Cisco as a replacement for an RMA. I updated the IOS, and after a reboot, was welcome to a funky looking prompt, and a "Welcome to Stardust!" banner. ...
I have two 1130 AGs and would like to have one connected to a wired net with wireless clients on the G radio, and connected to the other using the A radio, and it having clients on it G radio.
I can configure two APs as a bridge with one as an AP with RMW enabled, and the other in WGB mode. I have three VLAN, each configured on both APs with their own SSID. Each switch (cisco switches) port is in trucking with only the three vlan allowed....
Lost passwords, ran password recovery, file transfed, I can see the "Received 73728 bytes" but the PIX just hangs, never asks "Do you wish to erase the passwords?"It there a hardware reset?
I need an ACL to permit NTP from my PDC to My ext. time server.I belive this is how it should work......access-list 101 permit host (PDC) host (NTP server) eq ntpaccess-list 101 deny any any loginterf vlan 100 ip add 192.168.1.254/24 desc NTP serve...
Justin, Thank you, I belive leave you are right, but in this cisco dochttp://www.cisco.com/en/US/products/hw/wireless/ps441/products_qanda_item09186a0080094644.shtml#vlanwgpit states that WGBs do support VLANs when in infrasturcture mode. So I though...
Thank again Scott for your time and help. I am have a hard time configuing a non-root bridge, it is not an option in the GUI or the CLI. My APs are AIR-AP1131AG-A-K9 with software ver 12.3(8)JEA2.
Thanks Scoot, But that is kind of what I thought I was going. Any ideals on how to accomplish this? I thought the AP was the root and the WGB was the non-root.
