Use the Cisco IOS MIB Locator @ https://mibs.cloudapps.cisco.com/ITDIT/MIBS/servlet/index   Cheers ... View more

Link is not working.. Seems to be dis-functional after 4 years of its posting. ... View more

Great. What was wrong? Please share what you did to make it work and mark your post as answer, as it will serve as reference for others going through the same problem. Thanks ... View more

Not sure if this is causing the problem, but the aaa authentication command seems to be wrong. aaa authentication ppp vpdn local group radius aaa authorization network vpdn group radius local If you want to have a fallback to local authentication, you should use the commands below instead: aaa authentication ppp vpdn group radius local aaa authorization network vpdn group radius local Ideally, you should have only RADIUS: aaa authentication ppp vpdn group radius aaa authorization network vpdn group radius HTH, Gustavo ... View more

On ASR1K, BGP selective download for IPv4 is supported from IOS XE 2.3 onwards and for IPv6 from IOS XE 3.5 onwards. The configuration is as you posted before... As simple as it... I would suggest you to take a look at the BRKRST-3371 presentation from Cisco Live (www.ciscolive365.com) to have more info on some supported releases. Cheers, Gustavo ... View more

Hi Andre, So you are saying that if we have got FLASR1-BB-RTU license on the box we can't run sessions more than that, means system will not accept any new sessions once you have crossed the applied limits? Could you please confirm this? Thanks Hitesh ... View more

Hi Gustavo, Thanks for your reply. If I understand correctly the implicit ND is there and works only if I do not add an explicit deny ipv6 any any (or deny icmp any any). If I do add an explicit deny ipv6 any any for example to log packets matching I would have to include explicitly the permit icmp nd statements. This leaves open a question: quote=====IPv6 packets tunneled in IPv4 are not inspected.  ======= unquote How do I filter traffic to prevent reaching the router if the access-list do not work and I have IPv6 connectivity through an ipv4 tunnel? By the way, configuring the tunnel and the access-list the statement above appears to be not true. Cheers Fabio ... View more

http://www.cisco.com/c/en/us/support/docs/multiprotocol-label-switching-mpls/multiprotocol-label-switching-vpns-mpls-vpns/47807-routeleaking.html Route Leaking from a Global Routing Table into a VRF and Route Leaking from a VRF into a Global Routing Table This part can solve the problem. ... View more

If you do "show version" what does it say for configuration register, if it says something like 0xNN4N (where N is any number), then do these: config t config-register 0x2102 int fas0/0 no shut exit exit write mem reload ... View more

Thank you very much! I will read all that materials! ... View more