Hi All,
We are having this strange issue where randomly 2 calls out of 10 will have no voice , the call connects but the caller and called number don’t hear anything. If the called number then Holds/Un-Hold then there is voice . Basically when the RT...
Hi All,
I'm trying to figure out how to achieve a requirement where calls made from UCCX or CUCM IP phones display numbers from a pool of random DID. For example the calls will need to show 55554XXX (randomly). This range will be dedicated for the o...
Hi All,
I'm wondering if anyone have idea on this.
We have the following scenario where i need to maintain location and CAC support after i have implemented CUSP between the ingress gateway and CUCM.
PSTN===>Gateway====CUSP=====CUCM=== IP PHones
I ...
Hi All,
I'm trying to pull statistic's from a chat CSQ and i get -1 value.
Simple and short, is this step (Get Reporting Statistic ) supported for chat CSQ on uccx 10.6?
Thanks
Nour
Hi All,
I'm setting a Trunk between Cisco 3850 switches and HP for a customer, I have a problem with 10GB interfaces (Cisco and HP) where the speed Auto negotiation only achieves 1GB, any idea what i need to do to achieve 10GB? Also hard coding the i...
Hi Vivek,
There are about 5 remote sites with different link speeds.
What you said above is correct if the ingress gateway have a Trunk directly to CUCM. The Gateways have SIP Trunks to CUSP not CUCM. CUSP then forwards the calls to CUCM.
On your r...
Hi Paul,
Thanks for your responce. See below please
======================================
HP
======================================
B21 SFP+DA3 | No Yes Up 10GigFD NA off 0 (HP SFP) B22 | No ...
