Hi all.I've encounter a problem where the SNASW CP-CP session is randomly disconnected. Lately it happen very frequent. I've done some investigation:1) Using "show log" command, it displays as below: 2) When used command "show snasw pdlog id 340760 d...

Hi.Are there any solution to connect VLAN 1002 configured in non-cisco switch to connect to Catalyst 6509?

Hi All.I just got a demo unit of Cisco ASR 1002-F but the problem is the ESP and the RP not working. Here are logs:*Feb  2 18:22:09.292: %CPPHA-3-FAULT: F0: cpp_ha:  CPP:0 desc:CPP Client process failed: FMAN-FP det:HA class:CLIENT_SW sev:FATAL id:1 ...

Hi,I have built multiple GRE tunnel and one of the tunnel has been enabled ip flow. The confguration is as below.interface xxxip address xxxxip mtu 1400ip tcp adjust-mss 1360ip flow ingresskeepalive 5 3tunnel source xxxtunnel destination xxxxWhen I i...

Hi,My name is Zulkarnain Kamaludin from Kuala Lumpur, Malaysia. I have setup as follows: Users from outside networks need to communicate with inside host. The inside host only open a single TCP port let says port 15000 and only can talk to the TCP po...