Hi,I want to ask, if it is possible to have l2tp xconnect networks, and to do ipv4 default gateway on one of the xconnect peering devices for that network ?If I configure xconnect on an interface, I cannot configure IP address on it. I can teoreticly...
Hi,I want to limit from where users are able to access our ssl vpn (anyconnect VPN). So I wana to specify "allowed remote IP address of the client".For example to allow "just from Europe" access (suppose I know IPs used in Europe).Does somebody know ...
Hello,I experiment with OSPFv3 and encryption but without success.My configuration is 2x2901 with c2900-universalk9-mz.SPA.150-1.M4.bin (security and data licence) crossconnected thru s0/0/0 (tried HDLC and PPP)ospfv3 works well, but when I try to en...
Both take IP packet and insert it into another packet. Gre tunnel is not authenticated (it is valnerable to man in the middle attacks).IPSec tunnel is authenticated (you communicate only with something that approved its identity)GRE does not use encr...
Hi Mohan,best practice is to get public AS number (it is not a big deal).You didn’t tell us if Company X has its own addresses (registered to Company X), if so there will not be a problem. But if you plan to use Providers range of IPs, you must commu...
ok... just erase the line "set ip next-hop 172.24.32.250" and it will work.if you not specify next hop (or other policy routing that dicatates to omit routing table) inside route-map entry, traffic is routed thru Actual Routing. If you specify condi...
I'm still not sure about, what you want to do.If you dont specify next hop inside routemap, it will be routed according actual routing table (I hope )If you want to "deliver packet to local router" in a matter "my router should be destination" ... Yo...
I'm wondering if tunnel destination 3.3.3.3 is not just typo...i think static route:ip route 10.0.3.3 255.255.255.255 10.2.3.3is somehow a clue. If you can ping from one loopback to other one using command like:from R3: ping 10.1.1.1 source loopback...
