About willy moronta

willy moronta · 02-13-2014

Hello I've recently ran into a bit of problem with an added network segment.The basic network before said addition has clients connecting via distribution 2960s up to a 3750 which has L3 vlans IP routing enabled this sends all traffic to a CPE MPLS d...

willy moronta · 09-24-2013

Hi guys, I recently made changes to my network and I can get out to the internet but when I try google.com I can't browse to it, and I noticed that I also can not ping the sites I do browse to, I'm figuring its a return traffic problem wondering if a...

willy moronta · 09-20-2013

Hi guys, I've run into an issue creating a new internal network for secondary MPLS connection.I'm attaching a diagram of what the network looks like. In the diagram clients 1-2-3 all connect internally with no problems from one to another and they p...

willy moronta · 08-20-2013

Hello all, I've looked around lots for deploying MPLS using VRF where a single router is used at the CE location and how to go about accomplishing this.I'm trying to achieve something slightly different and I'm trying to figure out if a route map or ...

willy moronta · 04-23-2013

Hello I am running into an odd issue with clients connecting from one of our remote sites to our offsite email servers via owa - web connection.I'm attaching a visio to show a better understanding of what is happening but I'll describe it here as wel...

willy moronta · 01-07-2015

Ok cool, the phone is PID VID: CP7962G V15The phone was running on CUCM 9.1.2, but i am now using 8.6.2I don't know if it makes a difference, downgrading the firmware looking at this I'd say this is your problem. Its likely you upgraded the firmware...

willy moronta · 03-21-2014

You can probably accomplish this doing EEM scripting, but from a purely solution based view, I think assigning a VIP to 2 servers and configuring them for fail over may give you better results. In this scenario you have 2 servers sharing 1 virtual I...

willy moronta · 03-19-2014

Asus you have 2 ways to do this:1- i will separate the vlans among the switches (for example vlan 1&2 o switch 1, vlan 2 &3 on switch 2etc..)2-i will create subinterfaces on the router with encapsulation dot1q vlan number and dhcp helper under each ...

willy moronta · 02-13-2014

You make a very good point Jon Im assuming the sonic wall is NATin but it may not be - which would explain why I had to put in the route for 172.19.2.x on the ASA. I did this without thinking it through it simply clicked in my head that return traff...

willy moronta · 02-13-2014

Well yes the clients on 172.19.2.x have a gateway of 172.19.2.5 (sonicwall)This sonicwall has inside interface 172.19.2.5 this sonicwall sends all 0/0 (web) traffic to 10.10.10.3 (sonicwall interface directly attached to switch) Switch has GW of CE ...

Member Since	‎08-02-2012 11:32 AM
Date Last Visited	‎11-20-2018 08:40 AM
Posts	30
Total Helpful Votes Received	5

User Statistics

User Activity

NAT and throughput problem

Can browse internet but no ping replies

External routing problem with certain subnets

Best way to deploy MPLS with separate ISP for internet

Clients on same LAN take different paths

Ok cool, the phone is PID VID

You can probably accomplish

Asus you have 2 ways to do

Re: NAT and throughput problem

NAT and throughput problem