I've had this issue with 2 RMA'd OE612s already. They originally shipped with 4.0.19, which worked fine, but failed on upgrade to 4.2.1.Recovery attempt #1 with 4.0.19 Rescue disk displayed : MODEL: UNKNOWN FLASH: found, directory validated COO...
Hi Zach,>What led you to change the Adaptec configuration? I was directed to do so by TAC, although I wasn't sure why, since our other WAE-612-k9s didn't have this option enabled.>What is the state of the device prior to upgrading? Does the WAAS sof...
Hi Zach,Sorry for the delay. I've found that the MODEL detection is affected by the BIOS settings of the Hard Drive Controller. If RAID is hardware enabled on the Adaptec, then 4.1. and 4.2 detects the OE612 as an OE512, and 4.0 will show the MODEL a...
Hi Ravi,I've had interface issues with inline cards whenever there's a speed difference, ie. 100m vs 1gb, etc, with the LAN/WAN endpoints. I'm not sure what type of interfaces your Netenforcer uses, but the following link may be helpful.http://conft....
