Cisco requirements state "FC ports should end on last port of the module".. I would assume that means last port of ANY module and not the last ports of the "last module"?Just confirming when installing a "n55-m16up" (16 port expansion module) into a ...
When bpdu-filter is configured at the interface level.. am I correct to assume it still continues to relay BPDU's it has received from other switches on other non-filterwed swichports out of the interface configured with bpdu-filter? (handled like re...
I'm assuming based on Cisco's documentation that boot from iSCSI on UCS blades is now fully supported (as in TAC will provide support for an problems now)? Correct?Cisco UCS boot from iSCSIhttp://www.cisco.com/en/US/docs/unified_computing/ucs/sw/gui/...
Is it possible to configure the ASA to:log syslog informational to one hostandlog syslog critical to a different hostIt seems that the ASA allows you to only specify 1 logging severity level for all syslog hosts..Regards,
sorry.. I'm not sure if you fully understood my question.. yes I understand that enabling it globally .. filtering applies to all interfaces and its portfast interaction..... this is clearly documented by ciscomy question was specifically based on bp...
Ahh.. Just found the new CVD "VMware vSphere Built On FlexPod With IP-Based Shared Storage"http://www.cisco.com/en/US/docs/unified_computing/ucs/UCS_CVDs/cisco_ucs_vmware_ethernet_flexpod.htmlMy other question still stands.. has anybody noted any cav...