About PeterJacobsen

PeterJacobsen · 05-02-2016

Hi Guys Does anyone know the definition/output of NX-OS command “show hardware internal carmel crc”? The output is eight column table, like below. I can’t find explanation of the column names like MM tx CRC etc.I know about Tx Rx and CRC, but not the...

PeterJacobsen · 10-31-2013

Hi groupI have a question regarding LAG in HA setup; do you configure two port-channel, one for each controller or, only one port-channel for both?I have a stack of 3 x 3750x, and 2 x 5508 with each two Gigabit uplink in use.Active controler (5508-1)...

PeterJacobsen · 04-20-2013

Hi guysI have an odd issue after upgrading from WISM1 v7.0.230 to WISM2 v7.4.100I have made an AP Group an added all my WLAN (SSID). When I move AP from Default-group in to this group the new clients don’t get an IP address on any WLAN (SSID) When I ...

PeterJacobsen · 04-03-2012

Hi GuysMy company is beginning to have a lot of sites were we are stacking 3 to 4 C2960S-48 switche.This is making "show running-config" very very long because of the 4 x 48 interfaces.I can’t find a CLI command that show me the running-config of a r...

PeterJacobsen · 01-14-2010

Hi I use WCS v6.0.132.0 to manage my 4402 and 2106 controller both running version 6.0.182.0When I try to add another 2106 over DM-VPN it fails with the following errors:”No response from device, check SNMP communities, version or network for issues”...

PeterJacobsen · 05-22-2016

Thank you very much Furose for your time and explanation. :-) Peter

PeterJacobsen · 05-21-2016

Thanks Furose But what is the difference between MM Tx Stomp and FI Tx Stomp?

PeterJacobsen · 11-18-2013

The right solution is two etherchannels.BG,Peter

PeterJacobsen · 10-31-2013

Thanks Stephen for your reply.The switch doesn’t see which of the two port-channel that is on the active controller right? If WLC01 is the active one in PO1 and standby is WLC02 in PO2, the MAC of the active controller (WLC01) will be sending on PO1....

PeterJacobsen · 10-31-2013

What if you have two controllers in HA setup, do you configure two port-channel, one for each controller or, only one port-channel for both controllers?TIAPeter

Member Since	‎11-02-2005 07:59 AM
Date Last Visited	‎01-18-2023 12:00 AM
Posts	36
Total Helpful Votes Received	5

User Statistics

User Activity

Definition of "show hardware internal carmel crc"

One or two LAG port-channel for 5508 v7.4 in HA setup?

Clients stoppes get IP address after changing AP groups

Running-config on stacked switches (C2960S)

Can’t add Controller over VPN in WCS v6.0.132.0

Thank you very much Furose

Thanks Furose

One or two LAG port-channel for 5508 v7.4 in HA setup?

One or two LAG port-channel for 5508 v7.4 in HA setup?

Re: LAG - Link Aggregation