About steven.t27

steven.t27 · 02-05-2015

I have BGP peering with carrier. I would like to only accept routes from the carrier that I am interested in.My Router : 128.100.1.1router bgp 64514 no synchronization bgp log-neighbor-changes neighbor 10.10.10.2 remote-as 64514 neighbor 10.10.10.2 n...

steven.t27 · 01-11-2015

HiI have enabled an EIGRP peering between Nexus 7706 and Cat 6509.The peering came up ok and routes are being advertised. I am not too sure about the route-map settings.Below is my configuration on the 7706ip access-list EIGRProutes 10 permit ip 10....

steven.t27 · 01-07-2015

Hi AllI have a 4510R+E with 4 48 PoE switch port line cards and 2 supp engine.In an event of a power failure. Is there a command that I can shut down lower priority line card to save power on the UPS?From the output below, I have lost PS1-2 and PS2-2...

steven.t27 · 12-10-2014

I currently have etherchannel configured to 2x 10g ports.Cat_6509#sh run int ten8/1Building configuration...Current configuration : 156 bytes!interface TenGigabitEthernet8/1 switchport switchport mode trunk channel-group 42 mode desirableendCat_6509#...

steven.t27 · 10-29-2013

Hi AllEquipment: WS-C3750X-24T-SIOS: c3750e-universalk9-mz.152-1.E.binI am trying to setup iptv on a simple network but I am having issues with.Have attached my config!My server is connected to port 9 and a stb connected to port 10.My stb interface i...

steven.t27 · 01-16-2015

I believe I am having this issue as well on my 6509. Did you get this resolved?

steven.t27 · 01-14-2015

Works like a boss! Prefix List for the win!

steven.t27 · 01-12-2015

ip access-list EIGRProutes 10 permit ip 10.10.2.0/24 any 20 permit ip 10.10.12.0/24 any 99 deny ip any any !route-map EIGRProutes permit 10 match ip address EIGRProutes !router eigrp OP6kPEER autonomous-system 200 redistribute direct route-ma...

steven.t27 · 01-12-2015

Hi RezaI have only permitted 10.10.2.x and 10.10.12.x in my access-list I can post the config tomorrow. I have also tried to add a deny statement at the end deny any any but it didn't work.Thanks

steven.t27 · 01-08-2015

Hi Paul 4510#hw-module module 1 shutdo4510#hw-module module 1 ? reset Reset module in specified slot4510#hw-module module 1 No shutdown options

Member Since	‎07-02-2009 02:35 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	34
Total Helpful Votes Received	4

User Statistics

User Activity

Basic BGP Route Filter

EIGRP Route Map; Nexus 7706 and Cat 6509

Disable power to line cards on 4510R+E

LACP using 2x 10G ports not showing 20G?

Simple Multicast LAN

I believe I am having this

Works like a boss! Prefix

ip access-list EIGRProutes

Hi RezaI have only permitted

Hi Paul 4510#hw-module module