Anyone using Anyconnect 4.x w/ Two-factor Authentication experiencing this bug?
AnyConnect fails to pre-fill secondary username with dual authentication
https://bst.cloudapps.cisco.com/bugsearch/bug/CSCuv45057/?rfs=iqvred
Kevin
Hi all, Just looking for comment if I should continue with the actual upgrade from ISE 2.1 to 2.3. Looks like URT to run successfully (after all the kinks), but the 'Time Estimated to Upgrade" gave an error.thanks in advance!KevinMyISEBox/admin...
Hi all,
Anybody seen this before on the front page when going to https://<wlc ip>
You're still able to login in, but then the Dashboard doesn't show. You have to go to the frameset.html page manually. Even after that, everything doe...
hi, Wonder if anyone can give me some insight.CUCM5.1.3.a w/ 4 subscribersI took a set of Backup image and trying to restore them on a test MCS server (same hardware). I'm only restoring the publisher, not subscriber.I built a clean 5.1.3a CUCM w...
When an AP is discovered, WLSE stores SwitchIP, portIfIndex, portIndex, portModuleIndex pair for the AP. However, if the switch is rebooted and portIfINdex is changed, WLSE doesn't recognize the ifIndex has changed and reported the AP is down.Any t...
Hi,This issue disappeared by itself.Either,1) Browser version updated, or2) Clear Browser caches, or3) WLC version updated (which I doubt).Good luckKevin
Maso, I saw the same thing when I was trying upgrade from 7.0.3(IX1.2) to 7.0(3)I7(6). Upgrade to 7.0(3)I7(3) first, then upgrade to 7.0(3)I7(6). give it a try. Kevin
