I have a 2811s doing many VPNs to partners and clients. These routers are on my "VPN" network off a PIX 525. I use static routes on the PIX to get the traffic from my networks to the appropriate router and then down the VPN. This has been the setu...
Running 12.4(17) (c3825-advipservicesk9-mz.124-17) on a 3825 (w/VPN module) in my lab. I have a working VPN tunnel to an older 12.3 IOS router. It's a basic crypto map, so I'll no include the config. It does work. I can bring it up with interesti...
I'm trying to convert a crypto map VPN to a ip unnumbered VTI. The crypto map has been working for months. The VTI... no so much. Here are the applicable config entries.### original config!crypto isakmp policy 30 encr 3des authentication pre-share...
Got the answer from TAC. For some reason, the developers added a new command to turn these messages on (it's off by default). In the past, it's always been on by default (with no way of disabling it).! In config tcrypto logging sessionThat turns it...
BTW, as far as I can tell, the CRYPTO-5-SESSION_STATUS messages *should* be there.http://cisco.com/en/US/products/ps6350/products_configuration_guide_chapter09186a0080455af9.htmlMikeG