Is it a best practice to use the PIX interface as the LAN gateway ?We use to have our cisco 3845 gi0/1 as the LAN gateway before a re-design and now, the LAN responce time is really slow, could this be a cause of using a PIX as the LAN gateway ?Than...
In site A, I have a cisco 3845 with a two T1 (WAN) betwe is the show intAttached are the end point show interface and sh queue.On the Mpls site the is just massive latency , packet drop, how can I fix thies problem, could it be a telco problem?
I have a FTP server called Ftptran sitting behind a PIX "interface general" a. My network diagram Traffic from the ftpserver should pass the pix to the VPN then the destination. I'm having problem with the tunnel , the problem is with my local h...
In my Pix 515e there is an access-list entry : access-list out_acl permit tcp any host 69.67.67.100 eq smtp( 69.67.67.100) is the public IP address of the Mail server.do I need this ?, can somebody explain to me what this access-list is doing ?.Why s...
My goal is :- we want port 25 from specific outside addresses ( 208.75.194.0/21) to be allowed to: my1.cbc.com (notes) and mys.cbc.com (notes1) This is my partial configname 10.101.91.14 Notes1name 10.101.91.13 notesname 208.75.194.0 Mx_lo...
!. The PA-T3 is in the slot 5, but when I issued sh controller t3, it only show the module in slot 6.but this is the informationI issued show controller in other the have the " One port PA-T3+" card listed. From 7206MPLS-RT1>e...
