Hello,
We recently swapped out a 2821 router with a 4331. After the swap, paging works but the complaint is the voice coming through is garbled and hard to hear. The config from the old router is applied to the new router. The paging did not have th...
Hello, I am trying to upgrade the IOS on 2951 router through prime. These are the messages I am getting: SWIM1125: Failed to copy the image to Flash due to the reason - the SNMP set operation failed. Make sure you entered a valid SNMP Write communit...
Hello, I am trying to upgrade the IOS on 2951 router through prime. These are the messages I am getting: SWIM1125: Failed to copy the image to Flash due to the reason - the SNMP set operation failed. Make sure you entered a valid SNMP Write communit...
Hello, I was notified that a router at one of our customer locations went offline but came back up shortly after. We are getting errors on the interfaces. I am not sure what the errors are from? Here is the config: DO-SR-3700#show controllers t1T1 2...
Hello, I have a 4500X switch with 5 fans. Fantray 1 is louder and working harder than the rest. We replaced the fan but same result. Our other 4500X switches do no do this. Any ideas what may be causing this? Chad
Hello Manish,
Thank you for your response. The only issue is paging traffic. We made more adjustments on the voice port and were able to get one room to sound clear but all others are still muffled a bit? We even adjusted the settings on the paging ...
Mohammed, Thank you for your recommendations they worked. I just needed to re-register the phones to call manager. After that it worked. Thank you,Chad
