I believe the memory installed on my NME-CUE module has quit working. The following can be observed when it boots:Nmi Npx0 Dly P92 Sha0 Kbd0 Cmos Pci Dma0 PrtB Tim Exp Rfsh GeomInitializing memory.  Please wait.It then is stuck indefinitely at this s...

I'm using a Cisco WRT600N (1.01.36 build 4) and cannot figure out how to keep the DHCP server disabled. There's another DHCP server on my network, and the WRT600n messes things up all the time. Disabling the feature on the WRT600n, then rebooting kee...

I'm using a Cisco WRT600N (1.01.36 build 4) and cannot figure out how to keep the DHCP server disabled. There's another DHCP server on my network, and the WRT600n messes things up all the time. Disabling the feature on the WRT600n, then rebooting kee...

I have a Cisco SD208P. Is this a PSE of type A or B (endspan or midspan)? The switch does not seem to power PoE devices via the data pairs only.Please advise.

I have a Sipura 1001 ATA and am trying to do a factory reset by phone since the unit has an unknown or no known IP address.Steps as per documentation1) Dial ****2) 73738#3) Confirm with 1, as necessaryIssue: No dial tone to reach IVR in the first pla...