dear All, i have configure cisco OER and working however i need to track the destination and if one of the line track down then the oer will make the route to another line, is it possible and any sample for this?
if you are not using the serial interface then it wont do anything. if you are using the serial interface, and are acting as the DCE (pretty sure its DCE and not DTE) then you must use clockrate command. It is used when you are providing clocking o...
dear ramnetiindia, i ams sure your router memory not eoungh to support a lot of NAT, upgrade memory or upgrade router is the best choice, from the statistic, i think cisco 2811 is needed.