About saeedccie

saeedccie · 07-06-2012

Hi,We have ASA FW 5010 in our organization and we have 4 DMZ's under the DMZ interface on ASA and all DMZ's are created on sub interfaces and assigned different VLANS on each DMZ's likeDMZ-1 = 172.20.1.x - VLAN 1000DMZ-2 = 172.20.2.x - VLAN 1200DMZ-3...

saeedccie · 12-20-2011

Hi Folks,Can anybody confirm me i have 2960 series switches and Routers but when I'm configuring with Op Manager with Temperature traps so it couldn't working on Op Manager.Can anybody tell me is this any issue with Op Manager products OR temp. is no...

saeedccie · 11-03-2011

Hi Guys,I have a stupid question that i would like to asking you guys we have switches and routers that are "Interfaces on Gi" but our machines are on 100mbps speed so is there any advantage for this?I mean can the speed triple for the machines that ...

saeedccie · 10-10-2011

Hi Guys,I have Pix 501 firewall and I'm just configuring the device for "Email Server" to allowing POP/SMTP but i have some questions please answer me to resolve the issue.Inside Interface Address: 132.147.162.14/255.255.0.0Outside Interface Address:...

saeedccie · 06-24-2011

Hi,I'm having one small issue with my Pix 501 6.3(5) firewall, I have configured these Acls.....Pix(config)# access-list LIVE_SMTP permit tcp any host x.x.x.x eq 25Pix(config)# access-group LIVE_SMTP in interface outsidePix(config)# access-list LIVE_...

saeedccie · 07-06-2012

Thanks for the reply.Can we break this feature on catalyst switches 2960 or 3560?

saeedccie · 11-04-2011

Hi,You may check your internet connection through website.www.speedtest.netwww.whatismyip.com/tools/internet-speed-test.aspI hope this can solve your problem.Regards

saeedccie · 11-03-2011

OK thanks.But on switches and router they can communicate fastly due to gigabit interfaces. Am i right?

saeedccie · 10-10-2011

When applying Acl below is the error.PIX501(config)# access-list outbound permit tcp 132.147.162.14 255.255.0.0 any eq 80ERROR: Source address,mask <132.147.162.14,255.255.0.0> doesn't pairAlso please tell me if i allow this whole network then what s...

saeedccie · 10-10-2011

Hi,Thanks for the reply but I'm asking about PIX FW.Sorry the inside IP: 132.147.162.15/255.255.0.0Email Server IP: 132.147.162.14/255.255.0.0So what subnet mask will use for Access-list?Pix(config)#access-list outbound permit tcp 132.147.162.14 255....

Member Since	‎06-22-2011 10:06 PM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	16

User Statistics

User Activity

DMZ Sub interfaces into sub interface

Temperature on Cisco Switches and Router

Gi - Layer3 Switches

PIX 501 Issue

Pix 501: POP Issue

DMZ Sub interfaces into sub interface

Bandwidth Mesarument

Gi - Layer3 Switches

Re: PIX 501 Issue

PIX 501 Issue