About mac_mac_net83

mac_mac_net83 · 07-25-2022

Dear Community, I have issues below and can't figure out why my Phase2 is not coming up, even my router and the remote end has the same transform set settings. Below is the log in phase 2. My router is 5.5.5.5 , remote is 3.3.3.3. The remote peer is ...

mac_mac_net83 · 03-19-2021

Hi Cisco Community, Hope all is well! If I am going to install a A900-IMA2Z - Ten Gigabit Ethernet XFP/SFP+ Interface Module on a ASR-920-24SZ-IM , will it automatically support 10G without installing any additional licenses? Thanks,Mark

mac_mac_net83 · 01-21-2021

Hi Folks, Based on Cisco documentation about NAT, the following ports are used during the overloading process. When configuring for PAT (overloading), what is the maximum number of translations that can be created per inside global IP address? A. P...

mac_mac_net83 · 07-18-2019

Hi members, I am currently troubleshooting a Gig interface that has increasing total output drops value.The Gig interface is connecting to a switch. We use subinterfaces on the router to connect to different circuits. I noticed that the total output...

mac_mac_net83 · 07-11-2019

Hi All, When setting community values under a route-map (set extcommunity xxxx) with the "additive" keyword, this prevents the new entry to overwrite the existing entries. However, is there such similar commands where you want to remove a particula...

mac_mac_net83 · 01-26-2021

thank you @Giuseppe Larosa

mac_mac_net83 · 07-18-2019

Hello Georg,That is what I did. It maybe overwhelming though looking at the QoS counters as well as its difficult to check if it is historical or not and sometimes depending on how your QoS is configured (nested, etc.) , you need to do some math to c...

mac_mac_net83 · 07-11-2019

HI Tim,Thanks for your comments.I am referring to communitly list under a route-map.Example as below:route-map abcd permit 10match ip address prefix-list xxxxset extcommunity 12345:1111 12345:2222 12345:3333 additiveI only want to remove 12345:3333.W...

mac_mac_net83 · 07-04-2019

THanks everyone! Looks like my routing is messed up. Thanks for the hints and comments. Appreciate it.

mac_mac_net83 · 07-03-2019

Hello Giuseppe R8 is my last hop router....sending joins from the Loopback interface: R8#show ip mroute 234.2.2.2(*, 234.2.2.2), 00:14:55/stopped, RP 11.11.11.11, flags: SJCLIncoming interface: FastEthernet0/0, RPF nbr 78.78.78.7Outgoing interface li...

Member Since	‎05-30-2017 08:43 PM
Date Last Visited	‎08-03-2022 07:48 AM
Posts	39
Total Helpful Votes Received	1

User Statistics

User Activity

IPSEC Phase 2 is always failing

A900-IMA2Z

PAT overloading

Total output drops due to QoS

community - additive and remove ?

Re: PAT overloading

Re: Total output drops due to QoS

Re: community - additive and remove ?

Re: RP-bit set - Multicast

Re: RP-bit set - Multicast