I am currently running Cisco Works 3.2 and for some reason, the IP Filters that I put in stopped running.  Thus the Device Discovery takes forever to finish.  Looking for ideas of what might have caused this to happen.  THANKS

Good Morning!  I have found that the Cisco Works Hardware & Graph Reports will not pickup "Stacked  Switches"  My network has converted from old 3500 & 3550 switches to the new 3750G and now 3750X switches.  The Hardware and Graph reports miss over 9...

I have a network of about 4600 devices.  One item that takes up alot of my time is "deleting" routers and switches in Cisco Works 3.2 when a device has been removed (like for office closure or new device was installed, but not with same IP address as...

Is there a setting in Cisco Works I can change for getting SNMP used instead of TFTP for pushing configuration changes?  I recently did a push to over 4500 network devices (routers & switches) in my network and found that Cisco Works was using TFTP i...

Is there a way to change Cisco Works to use SNMP to push Configuration Changes to routers & switches?  I recently did a push to the over 4500 devices in my network and found that Cisco Works was using TFTP instead of SNMP.  Is there a setting in Cisc...