About chandimal.karunarathne

chandimal.karunarathne · 07-13-2017

I am experience unusual problem with my new S190 two boxes, which can’t connect via serial interface or management interface. I have tried with management interface with default ip address+ port (http://192.168.42.42:8080, https://192.168.42.42:8443)...

chandimal.karunarathne · 02-09-2012

I have configure 887 ADSL router with attached configuration. But users cant access internet properly. (Ex: yahoo and gmail mail cant access)Therefore please check the configuration with my network design which I have attached.Thank you,Chandimal.K

chandimal.karunarathne · 12-15-2011

I am doing a installation on CiscoWorks 3.2. after two three weeks I found my syslog services is not working properly. Once I checked on the syslog.log its updated with the device logs as normal. But when I am going to generate report it’s not collec...

chandimal.karunarathne · 02-14-2012

Hi Alain,Thank you very much sir, your solution works. So its due to the mtu size problem. So agine thank you very much for your knowledge sharing. Chandimal.K

chandimal.karunarathne · 02-12-2012

Hi,Thank you Alain, Is there any other problem with my configuration? I have change the configuration as you told but problem still same. Still some web sites cant access via this ADSL router. Therefore can yu please check my configuration one by on...

chandimal.karunarathne · 02-10-2012

Hi Aliain, Thank you very much, i'll check it and let you know. Anyway is there any problem with my NAT rule? i have only one public ip that i have to use for email server access like i mention on the config. if i use nat command with "extendable" ke...

chandimal.karunarathne · 02-09-2012

can you please help me this is the configuration.! Last configuration change at 09:08:08 UTC Tue Dec 13 2011!version 15.1no service padservice timestamps debug datetime msecservice timestamps log datetime msecno service password-encryption!hostname S...

chandimal.karunarathne · 12-17-2011

hi, Thank you for your reply. but i didnt work. Then i restore the LMS server again. but anyway thank you for your support. after i reinstalled the new server, now in that server SMTP setting cat set. its gives "Invalid IP address or server name fo...

Member Since	‎08-20-2007 01:20 AM
Date Last Visited	‎10-25-2018 04:39 AM
Posts	11

User Statistics

User Activity

Can’t connect Cisco WSA S190 factory default settings

ADSL configuration with static NAT for mail server

Syslog Reports not collect Syslog.log file Messages

ADSL configuration with static NAT for mail server

ADSL configuration with static NAT for mail server

ADSL configuration with static NAT for mail server

ADSL configuration with static NAT for mail server

Syslog Reports not collect Syslog.log file Messages