I have some issues running ether-channel mode on. I have a 3120G Blade Switch (stacked). The blade switch connects to the blade servers (internal).Gi1/0/1 connects to eth0 and gi2/0/1 connects to eth1 on the blade server.Here is my configuration:in...
Hi,We have a 6504 in our lab and I tried to cofigure local SPAN on one of the interfaces. The set up is as follows, the 6504 has two uplinks ( bundled) and also the 6504 is connected to load balancer. I hooked up the swtich to a machine running wires...
Hi,We use a CISCO 6504 with a single SUP 32. Is there any specific SNMP trap and OID if the SUP 32 goes down or fails??? Also i need one for the system reboot. Thanks!!!
Hi I need oids and the related MIBs for cisco 6504 with supervisor 32:Fanstatus notification, Powerstatus notification, Interface up/down, BGP notifications like peer down bgp established, ospf notificationsThanks,Anudeep
Yes when i run my test with LACP everything works fine, but with mode on the switch does not recognize the server interface going down. With mode ON when i shudown the interface on switch, the server detects the link going down. Not sure if this is L...
Thnks, but i want to monitor bidirectional traffic and i want to filter port-channel (ether channel) traffic specially. On the wireshark i see much traffic like DNS, BGp etc. I want to monitor traffic from the uplinks. Thnks