Hello, I am trying to configure Two-Stage dialing on a specific E1 number on a Cisco ISR 4331. All available official documentations does not include IOS XE configurations. I have configured the below:!voice service potsno direct-inward-dial isdn!dia...
Hello Again,Lets start by making sure the jabber-config.xml file present in your TFTP server is updated.You can access it using the following: http://<cucm-ip>:6970/jabber-config.xml
Hi shivani,Would you mind looking up in your Route plan report the URI 8060. I once had a similar case where I was matching a Pickup group number and my DNA was showing otherwise. Please check and let me know.
Also, Cisco Unity Express only support...
