Hello all. I would like to know if someone can suggest or assist with the following:I have a client that is building a new data center. My task is to configure vPC between two Nexus 7010 switches that will sit at opposite ends of the building. T...
Hi All. I'll do my best to provide as much detail as possible. I'm looking for advice on network design.My company will be moving to a new location in the coming months. Currently, we are situated in a large office building over 5 floors. Each fl...
Hi All. I'm preparing for my BSMSN exam and i'm a bit confused about something. Cisco book recommends the following:Backbonefast - enabled on all swtiches in the networkUplinkFast - enabled on all wiring closet switches (access switches)My questio...
Mathieu, hello. I am running through similar excercises and testing different scenarios except with more routers. I observed that if you add the keyword "forwarded" to your "no mpls ip propagate-ttl" command that you are then able to successfully...
Atif, hello. I went with using the L3 over the peer-link and it worked fine, however, I still had my doubts about it so I opened a case with Cisco. they said you should not run an L3 connection over the peer-link. They also said it is not a suppor...
Guys, thank you both for your suggestions. i will go with Adams method for the keep-alive setup and with Atif's for the L3 adjacency. How do i give you both credit for the correct answer? Thanks.Wil
Stefano, hello. You would keep the same peer-link between your 5010s. What that would allow you to do is allow you to provide vPC to downstream clients. With the suggstions i made your 5010s become vPC clients of the 7010s. I have used this de...
Hello. Looks like you may have a spanning-tree loop. Think about something like the following:On N7k1: Eth 1/10 - Po11, vpc 11On N7k1: Eth 2/10 - Po12, vpc 12On N7k2: Eth 1/10 - Po12, vpc 12On N7k2: Eth 2/10 - Po11, vpc 11On N5k1:Eth 1/33 and 1/34, ...