About nipurwins

nipurwins · 08-22-2019

Hi,we plan to install around 700 SPA112 ATAs in our customers branches to connect faxes to our VoIP solution.Voice-VLAN is set the same on every branch switchport, but LLDP isn't available. So we have to initial set the VLAN-ID on the SPA112 to bring...

nipurwins · 06-16-2017

Problem is solved already. As I have no access to the Servers atm, I had to trace the SIP traffic with wireshark, only to figure out what SIP message the server sends to the Client. Our current ATAs just show "Registration failure, SIP-403", so I can...

nipurwins · 06-16-2017

I managed to register the SPA112 after capturing SIP traffic with wireshark. There were some SIP-401 and SIP-403 stats. Even syslog messages weren't sufficent to figure out what goes wrong in registration. So problem is solved but not I'm not convin...

nipurwins · 06-15-2017

I have this problem too.I can't manage to get the SPA112 registered with our PBX. Permanently messages like this: Jan 1 00:00:43 SPA112 user.notice sprvoip: cmd - 5, response 8 Our ATAs in the field (different vendor) show SIP status-codes like "SI...

Member Since	‎06-15-2017 02:43 AM
Date Last Visited	‎09-20-2020 09:27 AM
Posts	5

User Statistics

User Activity

Cisco SPA112 ATA: Change VLAN-Settings for factory defaults

Problem is solved already. As

I managed to register the

I have this problem too.I can