About ca_ingres

ca_ingres · 01-04-2012

I would like to raise the question, "Is running DWDM on a G652d fibers wll cause errors?

ca_ingres · 07-17-2009

We have a 15600 SDH node and we got the following alarms:1. Equipment Fail to Boot2. Control Bus FailureThis is on the same TSC card on Slot 10.Any thoughts?Thanks

ca_ingres · 06-27-2009

We have a CISCO 15600 SDH node and we have this alarm message: Clock Module frequency mismatch. The fimware of the TSC card currently installed is a sonet.Is there a way we can change the firmware from sonet to sdh thru software uploading locally or ...

ca_ingres · 01-15-2012

Dear Sir,I would like to give you the actual scenario/setup of our network.Let say we have these three nodes A, B and CA being a RoadmB being a roadm and C being an OLAOriginally, A to B link uses G656 fibers, B to C uses same G656 fibers. After a f...

ca_ingres · 07-03-2009

How do we know if the card has a sonet or an sdh firmware?

ca_ingres · 07-03-2009

Thank you very much.By mistake, they put a Sonet TSC Card in slot 10 as standby. Anyway, we have already changed the TSC card with sonet firmware to one with SDH firmware and the alarm was cleared. I have another question with regards to E1-42 cards....

ca_ingres · 07-03-2009

Thanks for your reply. I appreciate it very much.I have one TSC card with an SDH firmware(active) and the other has a Sonet firmware (Standby). I believe we are receiving this alarm due to this reason.My question is, can we change the firmware via so...

Member Since	‎06-27-2009 11:38 AM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	7

User Statistics

User Activity

running DWDM on G652 fibers

Equipment Fail to Boot Alarm on TSC Card

changing the firmware from Sonet to SDH

running DWDM on G652 fibers

Re: changing the firmware from Sonet to SDH

Re: changing the firmware from Sonet to SDH

Re: changing the firmware from Sonet to SDH