Hi,
You can try to use different camera cable if available. Most probably camera is bad.
If you have contract with Cisco, you can get it replaced by opening a TAC case with them.
Thanks,
Amlesh
Hi Frank,
Can you configure speakertrack connector detection mode to Manual and set serial number of Camera's as camera 1 and 2 and check?
Waiting for the results.
Thanks,
Amlesh
Hi,
In order to placed H.323 calls to IP address, you can set call setup mode to Direct.
For SIP dial out, change default transport to UDP (not a Cisco recommended method of dialling).
Thanks,
Amlesh
Hi,
It would be helpful if you can take a tcpdump from non-working VCS-C. Probably this is a firewall issue.
For the second query, if one VCS node in a cluster is down, all registration will move to another node and calls will work from other nod...
