You are probaly right. This problem occured in my config environment, using a very basic router. The...

Hi, Thanks for the answer. There is Static routing defined in the NAT router : - Destination 192.168...

Hello, I configured 3 VLAN on a SG350-28P : VLAN 1 (192.168.1.0 /24) +------------------------------...

I did a full reset this morning. I applied the same configuration and... it works now !!

Yes, they are Windows PC, and they can ping each-other when they are connected in VLAN1. I added the...

The route has been added, as suggested. From VLAN1, the packets are routed to the SG350, and then dr...

Hi, Thanks for the answser. The switch itself is a L3 ! It must do the routing (if not, what does L3...

Hello, I'm configuring a new SG350-28P, running with the latest frimware (2.4.0.94). Layer 3 is supp...

Hi, Thanks for the answer. Slightly better, but not yet perfect. Configuration is now : : - Firmware...

Hello, I have a SG300 switch, configured as follow : - L3 enabled - VLAN 1 : 10.0.10.0/24 (switch IP...

I'm the vendor... And I'm trying to provide a working solution to my customer.

No other workaround at this time (if we need to use some VLAN on the AP)... But I need a controller,...

I received news from the Cisco support : at this time, there is no Firmware solving this bug... Is t...

No, I don't have smartnet support... How can I contact support to solve this known bug ?

Hi Ric, thanks for your answer. Current SW is 8.2.141.0 Yes, I'm aware of that bug, it describes acc...