I got the following message when trying to telnet to our switch after upgrading from 3.3(4a) to 3.3(5b) on our MDS 9120 (after supplying my credentials):telnet login is temporarily not available as startup configuration is being applied. This was aft...

Within this field notice it states that: "The m9500-sup2dimm-gplug-mz.3.4.1.bin utility will run on SAN-OS Release 3.x running on Supervisor 2 modules." However when I issue the load bootflash:m9500-sup2dimm-gplug-mz.3.4.1.bin I get the following err...

I'm about to setup 18/4 modules and plan on linking those to our DR site that is using 14/2 modules. Any issues connecting those (currently on 3.3.2 code)? And followup question to that assuming it's OK to run like that:Prod site is Gen 2 supervisors...