About adammmorton

adammmorton · 01-22-2018

I have APIC-EM installed and use it to configure routers and switches. We use 1921s, 3750Xs, and 2960Ss. (I know, old and outdated but that's what I have to work with for now.) I connect the switches to the management port in my office to configure...

adammmorton · 09-25-2017

I have a template that adds VLANs and VLAN names to switches. For some reason when the template is pushed it will not create the VLANs on the switch. When I manually paste the config in, it works fine. Any suggestions. Note, two of the VLANs are ...

adammmorton · 03-27-2017

I'm trying to add a RO community string for discovery in the APIC-EM controller and get the following error:Unable to add Read Community; 400:undefindedMy community string has a @ < > and ! character in it. I'm assuming this is causing the issue as ...

adammmorton · 09-26-2017

You sir are a genius! Yes, I was referring to PnP templates. You are two for two with the correct answers to my posts. By adding vtp mode off to the config, it created the VLANs as you stated.On another note, you said "APIC-EM does not support day...

Member Since	‎03-27-2017 06:33 AM
Date Last Visited	‎08-24-2018 02:02 AM
Posts	4
Total Helpful Votes Received	7

User Statistics

User Activity

APIC-EM Device Inventory IP Address Issue

APIC-EM PnP Template Issue with VLANs

Issue With Adding SNMP RO String

Re: APIC-EM Template Issue with VLANs