mzouggagh
Level 1
Level 1
Member since ‎07-19-2017
‎03-13-2024

User Statistics

  • 18 Posts
  • 0 Solutions
  • 36 Helpful votes Given
  • 1 Helpful votes Received

User Activity

We have two independent active standby  FW-HA in pod 1 and two others FW-HA in pod 2.these FW inspect N-S traffic and E-W traffic.  PBR destination in an L3Out was the chosen design option. We configured one L3out to both FW-HA, but when we configure...
Hi, we wrote ansible script to create 200 vlan pool in ACI APIC, but execution is too slow. it take more than one hour to finish the job! With postman it take 2 minutes to create 200 vlan pool. how can we improve ansible time execution?  
after reloading C9300 switch (version 17.6.4), interface te1/1/4 go to down state, and log display: %SFF8472-3-READ_ERROR: Te1/1/4: Error reading DOM data from transceiver if I unplug / plug cable in Te1/1/4, interface go back TO UP state. (it is not...
I tried to add catalyst 3560cx as an extended node to SDA fabric but I have this error message: Device tried to contact the server and failed during certificate_install how can I resolve this problem? is it possible to add extended node without using...
we are using our local CA for SDWAN deployment.to do ZTP we tried to upload our root CA in PnP portal.as you can see in attachment, a warning message display:SAN in the certificate should match either the IP or hostname specified in the controller pr...
Community Statistics
Member Since ‎07-19-2017 12:03 AM
Date Last Visited ‎03-13-2024 12:02 AM
Posts 18
Total Helpful Votes Received 1
Helpful Votes From