About Comtrackllc

Comtrackllc · 04-24-2020

Dears,I have 5 ISE 2.6 patch 6.1 PRI(A),SEC(MNT)1 SEC(A),PRI(A)3 PSNIn the PAN license menu, it was showed the wrong base license count. I use bellow procedure:application configured ise Reset M&T Session Databaseon both PRI(MNT) and SEC(MNT)and i...

Comtrackllc · 04-27-2019

Hi,I configured my hub and spoke router with dVTI and policy base ip address assing to spoke router.Everything works fine but the IP address of speaking router tunnel don't show in routing table static and i cannot ping the tunnel ip address and then...

Comtrackllc · 12-30-2018

Dears, I deployed distributed ise nodes with five nodes.The two nodes are pan and three nodes are psn.but now I have two primary active pan and I can`t remove any of them. May you please help me to remove one of them or change it to secondary pan.

Comtrackllc · 03-14-2017

Hello while SM-2GE-SFP-CU has two Gigabit port , i can';t see more than 160Mbps downstream throughput from one of the ports , and in data sheet it said throughput of the SM module is 100Mbps bidirecttional , if this is true why it has two Gigabit po...

Comtrackllc · 04-22-2020

Dear,Thanks for your help.How can I find why the ISE base license consume.I have the same problem. I try to use profiling and after that my base license increase daily.The Ise showed license maximum 1600 per day. but after it it grows to 2500 and aft...

Comtrackllc · 12-31-2018

Thanks for the support.But when I select the pan node in the deployment page, deregister option change to gray and cannot select.

Comtrackllc · 03-14-2017

thank you Leo, i got my answer but router that SM module is on that, is 3925 with SPE100 , customer can get real 1Gbps from backplane GE ports of the router , while on SM module throughput is much lower what i want to know personally is this, you tol...

Comtrackllc · 03-14-2017

as i forwarded my colleague discussion, i guess he mean aggreate throughut of two ports on the SM card , or maybe 40Mbps send and 100 Mbps receive , not possible? in the meantime, main question is this: customer must not expect 1Gbps throughput on Gi...

Member Since	‎07-17-2016 03:08 AM
Date Last Visited	‎05-01-2020 12:02 AM
Posts	9

User Statistics

User Activity

ISE live sessions doesnt show anything

Problem, FLEXVPN with dVTI and assign ip address authomatic from hub but i cannt ping the tunnel ip address

cisco ise has two primary active pan nodes

Cisco SM-2GE-SFP-CU throughput

Re: ISE 2.4 Base License Sessions Exceeded Database error

Re: cisco ise has two primary active pan nodes

thank you Leo, i got my

as i forwarded my colleague