Hello, what is the best solution in order to set DSCP on a specific ip address in a VRF ? Whit no VRF I usually do in this way: access-list 101 permit ip host A:B.C.D any ! class-map low_p match access-group 101 ...
I have solved the first configuration applied to sub-interface works fine, It was a problem on visualization of the hits on ACL (I don't know why !) but looking the command sh policy-map interface po1.100 I see that the defined traffic is marked. thx
Ciao Giuseppe, thanks for your fast reply, can you explain me better; the host where I wanna set a specific DSCP is routed from a sub interface of a PO like Port-channel1.100 on a specific VRF how I can configure the DSCP ? thx
