Thanks for this suggestion, but as I reopened my project the switch, and I believe the router delete...

Just got home. Tried the new switch that is supported still no luck, take a look at the picture for ...

I'll do this when I get home.

I'll try this when I get home, thanks!

Yes nothing was trunking just the host connected to the router.

Well it works when plugged directly to the router so I was thinking it was something with the switch...

I hard coded the ports to full duplex, and still no luck. 

Thanks for the quick replies. Here is the arp table, and route print.

SW1(config)#do sh vlan brief VLAN Name Status Ports---- -------------------------------- --------- -...

I cannot. 

R1(config)#do show ip int briefInterface IP-Address OK? Method Status ProtocolGigabitEthernet1 unass...

Well It's on auto neg, so it should be fine right? Also in GNS3 they added templates for these VIRL ...

So I've set up a small lab in GNS3, and I don't know why I can't ping to my default gateway as I've ...

So I'm running the cisco IOSv router in GNS3, and I've noticed that it actually has interfaces when ...