Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
We would like to verify that jumbo frames are enabled and MTU size is to 9216, for all Layer 2 switches in our data center.
QUESTION: Is there anyway to set the interface MTU to 9216 bytes??
We have run the following commands:
1. # show ru...
Based on the outputs above, can we declare that jumbo frames has been enabled on this Layer 2 switch.
Does VLAN MTU config apply to Layer 2 switching?
Thanks.
