paolo_carbone
Level 1
Level 1
Member since ‎11-26-2012
‎02-15-2019

User Statistics

  • 23 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 5 Helpful votes Received
Recent Badges
10 Replies
1 Helpful Vote
5 Replies

User Activity

One of our ME3600 units has developed a problem where we would lose IPv6 Neighbours and OSPFv3 neighbours, followed by the device not passing MPLS traffic. IPv4 traffic suffering bad packet loss.I discovered that devices attached to the Gigabit ports...
I have a requirement to pass a Xconnect over an RSVP-TE signalled tunnel, but I do not have the option to add a preferred-route so the Xconnect always passes over LDP signalled LSPs.All examples I have seen suggest to use preferred-route under xconne...
I have 2 Juniper MX5 routers which connect with 2 ME3600 in an MPLS ring. They all run as PE routers as I currenlty do not have a requirement for separate P routers.I plan to have the full BGP internet table imported into an Internet VRF in each MX5 ...
Can QinQ packets be passed through a 2960 switch using VLAN trunks?I am receiving QinQ packets from a service provider on a trunk into a 2960 switch which then connects to an ME3600 via another trunk port which is configured with service instances fo...
Hi,I need to setup a Cisco 2921 with data license to work as a LNS using local authentication for just a handful of remote clients.Could someone advise on how best to configure this so that the all the tunnels are terminated onto a VRF and recommend ...
Community Statistics
Member Since ‎11-26-2012 08:37 AM
Date Last Visited ‎02-15-2019 10:16 AM
Posts 23
Total Helpful Votes Received 5
Helpful Votes From